mqtt-ir-remote/IRremoteESP8266/examples/TurnOnToshibaAC/TurnOnToshibaAC.ino

72 lines
2.4 KiB
Arduino
Raw Normal View History

2018-07-09 22:04:36 +00:00
/* Copyright 2017 David Conran
*
* An IR LED circuit *MUST* be connected to ESP8266 GPIO4.
*
* TL;DR: The IR LED needs to be driven by a transistor for a good result.
*
* Suggested circuit:
* https://github.com/markszabo/IRremoteESP8266/wiki#ir-sending
*
* Common mistakes & tips:
* * Don't just connect the IR LED directly to the pin, it won't
* have enough current to drive the IR LED effectively.
* * Make sure you have the IR LED polarity correct.
* See: https://learn.sparkfun.com/tutorials/polarity/diode-and-led-polarity
* * Typical digital camera/phones can be used to see if the IR LED is flashed.
* Replace the IR LED with a normal LED if you don't have a digital camera
* when debugging.
* * Avoid using the following pins unless you really know what you are doing:
* * Pin 0/D3: Can interfere with the boot/program mode & support circuits.
* * Pin 1/TX/TXD0: Any serial transmissions from the ESP8266 will interfere.
* * Pin 3/RX/RXD0: Any serial transmissions to the ESP8266 will interfere.
* * ESP-01 modules are tricky. We suggest you use a module with more GPIOs
* for your first time. e.g. ESP-12 etc.
*/
#ifndef UNIT_TEST
#include <Arduino.h>
#endif
#include <IRremoteESP8266.h>
#include <IRsend.h>
#include <ir_Toshiba.h>
IRToshibaAC toshibair(4); // An IR LED is controlled by GPIO4, NodeMCU D2
void printState() {
// Display the settings.
Serial.println("Toshiba A/C remote is in the following state:");
Serial.printf(" Power: %d, Mode: %d, Temp: %dC, Fan Speed: %d\n",
toshibair.getPower(), toshibair.getMode(), toshibair.getTemp(),
toshibair.getFan());
// Display the encoded IR sequence.
unsigned char* ir_code = toshibair.getRaw();
Serial.print("IR Code: 0x");
for (uint8_t i = 0; i < TOSHIBA_AC_STATE_LENGTH; i++)
Serial.printf("%02X", ir_code[i]);
Serial.println();
}
void setup() {
toshibair.begin();
Serial.begin(115200);
delay(200);
// Set up what we want to send. See ir_Toshiba.cpp for all the options.
Serial.println("Default state of the remote.");
printState();
Serial.println("Setting desired state for A/C.");
toshibair.on();
toshibair.setFan(1);
toshibair.setMode(TOSHIBA_AC_COOL);
toshibair.setTemp(26);
}
void loop() {
// Now send the IR signal.
#if SEND_TOSHIBA_AC
Serial.println("Sending IR command to A/C ...");
toshibair.send();
#endif // SEND_TOSHIBA_AC
printState();
delay(5000);
}